I like curves.......and big pipe.......I know it looks similar....but it isn't. This was my first project with my new upgraded welder. I made double passes on all welds and all the wires run inside the tubing. This was a very difficult T Top to make, due to the intergrated fit of the mounts.
Note: one drawback to powder coating is I found I needed 6 more rod holders after some fishing trips..... and once powder coated, can't weld them on. So I had to use clamp on holders. bummer.
Note #2. I added 6 rod holders low on the front tubes and like them so much that next time I will forgo the top-rear rocket launcher holders. They are too difficult to reach and when running, my outriggers hit the rods stowed up there.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.