t-baltic
Registered Member
- City
- Kaliningrad
Hey! I`m about to buy 150 opti 06, 298 hours, almost for my 191fs restore her, new wiring, new plumbing will post later....
So the compression is 95 to 105 psi(cold) on all six cill, but DDT test show that port side had overheating for 334 sec and STBS had 642 sec overheating in the past. And i can see that bolts on both heads was touched. My Q.is what else should i look and what it was that record this type of data as overheating. It was overheated block or it was just major overheating (etc as on most opis low press impeler or same thing).
Over all engine run g8,but those bolts........
So the compression is 95 to 105 psi(cold) on all six cill, but DDT test show that port side had overheating for 334 sec and STBS had 642 sec overheating in the past. And i can see that bolts on both heads was touched. My Q.is what else should i look and what it was that record this type of data as overheating. It was overheated block or it was just major overheating (etc as on most opis low press impeler or same thing).
Over all engine run g8,but those bolts........