rcargn
Registered Member
- City
- Simi Valley
To all 235 owners,
Got my 235 a few weeks ago. I noticed the front bow covers were not flush. I didn't see this until later, because the bow cushions were on. They are sticking up a good half inch. I thought initially that the rubber seal was obstructing the cover from seeding properly. I stood on them, but did not see any movement. They do lock, surprisingly. As I stood there, I also noticed the very front of the boat, where the cup holders are located in between the bow storage area is not symmetrical. I am really starting to believe that this problem may have been caused by a bad mold cooling process. I checked several online 235 articles that have pictures showing the covers perfectly flush.
Can all the 235 owners out there check their boats and let me know if you have the same problem.
Thanks,
Rudy
Got my 235 a few weeks ago. I noticed the front bow covers were not flush. I didn't see this until later, because the bow cushions were on. They are sticking up a good half inch. I thought initially that the rubber seal was obstructing the cover from seeding properly. I stood on them, but did not see any movement. They do lock, surprisingly. As I stood there, I also noticed the very front of the boat, where the cup holders are located in between the bow storage area is not symmetrical. I am really starting to believe that this problem may have been caused by a bad mold cooling process. I checked several online 235 articles that have pictures showing the covers perfectly flush.
Can all the 235 owners out there check their boats and let me know if you have the same problem.
Thanks,
Rudy