I had a strange thing happen last weekend while putting my 2008 195CC back onto the trailer. After driving onto the trailer, I was left about 2' short of being fully on. Usually this is no problem, just hook on the winch strap and crank it up the last 2'. When I attempted this I was only able to complete about 2 full cranks before the crank handle just spun on the shaft - no pull. I was able to get the boat and trailer out of the water and away from the ramp, and after inspecting the handle and where it attaches, I found that the crank handle had worn so that it wouldn't turn the winch shaft at all. I checked my EZ Loader warranty book and found that they do not warranty the winch. I also discovered that the original winch is only rated for 1800lbs. which I found strange because the 195CC with 150 Evinrude weighs at least 2500lbs.+ fuel gear, etc. I will be replacing the winch this weekend with another Fulton winch, only this one will be rated for 2500lbs. Has anyone else experienced a similar problem with a winch that is only 2 years old?